New Year snowflake 2017 with your own hands made of paper - a three-dimensional scheme, phased in large, origami, templates. How to cut a snowflake, a master class for children

Simple Christmas snowflake 2017 made from paper for children, master class

First we suggest you master a very simplemaster class of New Year snowflakes from paper with their own hands for children. It is so accessible in performance that it is suitable even for kindergarten. To make this simple New Year snowflake from paper, you can use for your children both plain white paper and colored sheets. A fine corrugated paper is also fine.

Necessary materials for a simple paper snowflake from their own hands for children

• 
  sheet A4


• 
  scissors


• 
  glue


• 
  markers


• 
  Scotch


• 
  stapler


• 
  decor (sequins, crystals, buttons)

Instructions for the master class of New Year snowflakes for children with their own hands

1. 
   We cut the sheet into strips 2-3 cm wide and about 15-20 cm long. The number of strips will determine how much the craft will be in the end.


2. 
   Each strip is wound on a marker or marker, fixing paper edges with paper tape.


3. 
   Leave the workpieces for at least an hour in order that they take a wavy form.


4. 
   Remove the paper strips from the markers and connect them with a stapler in the form of an asterisk.


5. 
   An ugly place of a joint we decorate with bright paillettes, beads or rhinestones. Also, if desired, you can add pieces of New Year's rain or paste confetti. Done!

3D snowflake 2017 with own hands made of paper, master class with photo

Volumetric snowflakes from paper with their own handsare considered to be one of the most difficult in terms of technique. However, if you have a detailed instruction with step-by-step photos, as in our next master class, then you should not be afraid of difficulties. We assure that after the first self-made volumetric snowflake with their own hands from paper, the remaining copies "will go like clockwork". Make sure of it by following the instructions below.

Necessary materials for bulk snowflakes from paper with their own hands

• 
  sheet A4


• 
  scissors


• 
  adhesive tape or glue

Instructions for a master class of snowflakes from paper with own hands

1. 
   For the next craft, you need a rectangular sheet with the following parameters: length - 25 centimeters, width - 18 centimeters.


2. 
   We bend the left lower corner of the sheet inwards, as in the photo below.


3. 
   Crop the extra edge to get an isosceles triangle.


4. 
   Fold the triangle in half.


5. 
   Scissors from the dense side of the bend make two shallow incisions, as in the next photo.


6. 
   We unfold the workpiece so that we get a diamond with notches. The inner corners of the central notch are joined together by adhesive tape or glue.
   
   
   On a note! If you use glue, you must additionally fix the workpiece, for example, with a clothespin until it completely dries.
   
   


7. 
   Repeat the procedure with the following edges of the notch, fixing them in the opposite direction with the first workpiece.


8. 
   The edges of the last notch will also be fastened together, but in the opposite direction.


9. 
   The result should be the following construction.


10. 
    For one volumetric snowflake, 6 to 8 such blanks will be required. They can be made in different colors to add a color to the crafts.


11. 
    Using adhesive tape or glue, fix all the blanks according to the template below.

Beautiful big snowflakes 2017 with your own hands made of paper - in stages with photos

Make a beautiful paper snowflake with your own handsfor the decor can be quite large. Such a decor will certainly attract everyone's attention and become an interesting interior solution on the eve of the New Year. How to make a beautiful big snowflake with your own hands from paper step by step learn from our next master class.

Necessary materials for a large paper snowflake with your own hands

• 
  sheet A4


• 
  Ruler and pencil


• 
  glue


• 
  clothes pegs


• 
  Christmas garland, glitter

Instruction for a step-by-step master class of a large beautiful snowflake with your own hands

1. 
   First you need to cut thin paperStrips in the amount of 20 pieces, 10 strips on each side. The longer they are, the larger the size of the finished work. Then we arrange five strips in a row with small intervals, and on top we spread five others on the principle of braids.


2. 
   The resulting workpiece is rotated so thatBefore us, it lay in the form of the letter "X". Now we connect the adjacent, and then the last, strips and glue them. Top with pegs until completely dry.


3. 
   Repeat with each side. As a result, there should be one strip on each side, forming a thin cross.


4. 
   Leave the workpiece to dry completely for about half an hour. Then remove the clothespins and go to the second identical part of the craft.


5. 
   We connect both parts together, turning the bottom of the snowflake by 45 degrees. Now the free strips can be fixed with ready-made rays.


6. 
   We glue them with glue and fix them with clothespins, leave them to dry completely.


7. 
   It remains to decorate the finished snowflake. This can be done with pieces of a New Year's garland and sequins.
   
   
   On a note! Instead of sequins from the store, you can use broken Christmas toys. To do this, you should carefully crush, rolled in a thick fabric, a glass toy with a rolling pin. The resulting crumb should be mixed with transparent glue and then used to decorate the crafts.
   
   

Snowflake 2017 from the book for the New Year with their own hands, a step-by-step master class

In the next step-by-step master class snowflakes onNew Year's own hands will do from the old book. It's a great way to breathe new life into her yellowed pages. Call a snowflake from the book for the New Year with your own hands (step-by-step master class below). It just can not cope with small children. This is more a master class for creative adults who do not perceive the making of Christmas decorations exclusively as children's entertainment. Conversely, with pleasure create beautiful and exclusive elements of decor.

Necessary materials for snowflakes from the book for the New Year

• 
  book sheets


• 
  glue


• 
  sequins


• 
  ruler and a simple pencil


• 
  scissors


• 
  line

Instructions for step-by-step master-class snowflakes from the book for the New Year

1. 
   To begin with, it is necessary to draw book pages into strips 2 cm wide.


2. 
   For one side, you need 7 such bands: 1 full page length, two 2 centimeters shorter, two shorter by 2 cm than the previous ones, and two stripes 6 centimeters shorter than the first.


3. 
   The longest strip should be folded twice as a loop, gluing the bottom edges together. On the sides it is necessary to fold the strips shorter, also gluing their lower parts, as in the photo below.


4. 
   Repeat such manipulations with the remaining strips and fix them under heavy oppression, for example, a table lamp.


5. 
   When the blank dries, you should additionally fix its edges with a thin line. In general, 6-8 such blanks for one snowflake will be required.


6. 
   Draw the book sheet again into strips of the same length. Cut and fold into a tight ring, tie with a fishing line. The ring can also be additionally smeared with transparent glue.


7. 
   After complete drying, go to the craftsman's combination. To do this, the end of the workpiece is densely glued with glue and connected to the ring.


8. 
   We repeat with each workpiece.


9. 
   In order to better fix the snowflake, we glue the outer loops of neighboring snowflakes with glue.


10. 
    As a decor fine glitters that should be applied on the side edges of snowflakes are suitable. You can also use pieces of garland, sequins, small beads.


11. 
    Then you need to make a loop from the line, so you can attach a snowflake, for example, to a Christmas tree. Done!

Children's snowflake from paper with their own hands in origami technique, master class

The art of origami is multifaceted and difficult, butwith the correct instruction in this technique, you can make by yourself and a fairly simple hand-craft, for example, a children's snowflake. True, to be frank to the end, the next master class with photo can not be called solely in the technique of origami. In it for children's snowflakes from paper with their own hands, in addition to the origami technique, they will also use threads with scissors.

Necessary materials for origami children's snowflakes for the New Year

• 
  dense color sheet


• 
  pencil and ruler


• 
  needle and thread


• 
  scissors

Instruction for a master class of children's snowflakes in origami technique

1. 
   To begin with, we cut out a strip 5-7 cm wide andlength about 20 cm. Using a pencil and ruler, make notes on every centimeter along the length. From above, cut out the imitation of the "fence", as shown in the photo. In the middle of the resulting columns, we draw small diamonds. Then the points mark the middle of each centimeter and pierce them with a thin needle.


2. 
   Now take the ruler and put it on top of the firstA line dividing our section of "fence" in half. Gently bend the workpiece inward, and then remove the ruler and bend it in the opposite direction. We repeat the same with each section. In the end, you should get an accordion, as in the photo below.


3. 
   Tightly hold the accordion with the fingers of one hand and with scissors we cut out the previously planned rhombs in the middle of each section.


4. 
   We take a needle with a thread and gently we pass it through small holes, which we already pierced with a needle two steps back.
   
   
   On a note! The thread must be taken tight, so that it firmly holds the finished structure!
   
   


5. 
   When the thread has already passed through all the points, insert it again into the first hole to close the structure.


6. 
   We remove the needle and begin to gradually tighten the thread, until a dense ring is formed. We tie a string on a knot, and on top of the snowflake we put a coil to straighten it.


7. 
   From the remaining thread form the loop and our children's snowflake is ready! And for those who want to learn the pure technique of origami to create snowflakes, we have selected a video lesson with a step-by-step scheme below.

https://www.youtube.com/watch?v=tKxs-1uOL2Y

Openwork snowflake with own hands in the technique of quilling with their own hands, master class with photo

Quilling is a real art of weavingamazing beauty of hand-made articles and postcards from simple strips of paper. With the help of quilling techniques, you can create truly unique fishnet snowflakes, a direct confirmation of what our next master class with step-by-step photos. But the most surprising is that by swapping individual parts and adding new elements you can create several different openwork snowflakes with your own hands in the quilling technique in one general scheme.

Necessary materials for openwork snowflakes in quilling technique

• 
  sheet


• 
  pencil and ruler


• 
  scissors


• 
  glue and brush


• 
  awl

Instruction for a master class of openwork snowflakes in quilling techniques

1. 
   Using a ruler and a simple pencil, you need to draw a sheet. To do this, by the width of the sheet we make marks of 0.5 cm and draw the lines along the entire length. After cutting the strips with scissors.


2. 
   To form rolls you will need an awl. On it we wind the strip rather tightly, and then let the roll spread out a little and glue the edge to its base.


3. 
   At the heart of the snowflake will be one round element and six drop-shaped rolls. To get the element in the form of a drop, you need to lightly press one end of the round roll with your fingers. We connect the structure with glue.


4. 
   Now we add to the base six rolls in the shape of the eye. They will also be made from round rolls, but having already flattened their fingers with both edges. Glue the "eyes" between the drops on the template below.


5. 
   Now we need small rolls, soThe standard strip is folded in half and cut into two parts. From each small stripes we twist a small round roll. To start, you need six pieces of such elements.


6. 
   Small rolls glued along the edges of the elements in the form of a cat's eye.


7. 
   Twist the six standard large rolls.


8. 
   We glue them to the drop-like elements, as shown in the diagram below.


9. 
   Now we need square rolls in the number of six pieces. We will form them from standard round ones, slightly flattening the sides in the shape of a square.


10. 
    Squares are glued to the large round elements, pre-turning them into the shape of diamonds.


11. 
    It remains to twist the big round roll according to the standard scheme and glue it to the top of our craft. We give a completely snowflake to dry and thread the thread through a large roll. Done!

How to cut a New Year's snowflake 2017 from paper with your own hands, charts and templates

The easiest way to make a New Year's snowflakewith their own hands - is to cut it out of paper on a ready-made template or pattern. Such simple, but at the same time very beautiful snowflake with their own hands are available primarily for children's creativity. However, there are quite complex schemes with which you can make even large and voluminous decorative snowflakes, which by their originality will not yield to handicrafts in the origami or quilling technique. Do you want to learn how to cut a beautiful New Year's snowflake from paper with your own hands? Then a selection of photo templates and schemes for adults and children, as well as video lessons, you will find further.