Lace making: tatting for beginners

Weaving lace can be performed on knitting needles, on bobbin, and also with the help of special shuttles. It is this last kind of lace andcalled frivolite, which from French means "lightweight, weightless." And the truth is, the products made in the technique of frivolity are characterized by incredible airiness.
Frivolite for beginners: materials and tools
For weaving lace in the technique of frivolity shuttles are used. Shuttles are specialpribosobleniya, which winds the thread for frivolity. Shuttle for tatting is made of wood, plastic, metal, plexiglas, ivory. They differ in size and design. Are selected depending on the thickness of the thread. For beginners it is enough to buy or manufacture 2 shuttles.
Threads for frivolite are used in cotton, woolen, linen, nylon. It is important that the thread is firm and not torn during operation. The thickness and color of the thread are selected depending on the desired pattern.
For frivolite, in addition to yarns and shuttles, small scissors, a kneading needle, and various accessories will also be needed.
Frivolite for beginners: weaving the main unit
During weaving tatting The shuttle is held in the right hand, between the thumb and forefinger. The shuttle is parallel to the fingers, the end of the thread exits the rear end of the shuttle. Here's how it is necessary to prepare the thread for the beginning of the weaving:
- With the thumb and forefinger of the left hand, take the thread from the hook, leaving the area about 4-5 cm free;
- thread the arms of the left hand, then again clamp it between the thumb and forefinger;
- Take the shuttle in the right hand, the thread follows the shuttle from right to left;
- The thread that forms a loop on the left hand is called the working thread, and the thread leading to the shuttle is the leading one.
The main elements of the frivolite are the knot, ring, pico, arc. Knot in the weaving technique of lace tatting only one is used - it is called "knot of frivolity". There is a knot of frivolite or, as it is called, a complete knot of two parts. This is the forward and reverse nodes.
Here's how to run a direct node:
- make a cassock on the right hand;
- bring the shuttle under the working thread;
- The working thread should slide between the index finger and the hook, and then backward - between the thumb and the shuttle;
- simultaneously squeeze the fingers of the left hand and pull the shuttle to the right;
- straighten the fingers of the left hand, while tying the knot from the working thread around the lead.
Here's how the reverse node is executed:
- when weaving the reverse knot, the cap on the right hand is not done;
- The shuttle is to drive over the working thread, it must slide between the lower edge of the shuttle and the thumb;
- Lower the shuttle down and pull it in the opposite direction - the working thread must slide along the top face of the shuttle;
- further loosen the working thread, pulling the lead at the same time;
- slowly straightening the fingers of the left hand, tighten the knot and bring it closer to the thumb and forefinger of the left hand, hold it tight.
The straight and reverse frivolite knot, connected in series form full knot of frivolite. Nodes must fit tightly to each other. If, after plaiting several complete nodes, the leading thread slides freely, then the knots are woven correctly.
Weaving lace in the technique of frivolity is a refined art that requires perseverance, accuracy of movements, patience. But magnificent air products, which withThe frivolite can be weaved by oneself, the long work of the needlewoman is more than rewarded, pleasing her with its beauty. Collars, napkins, all kinds of jewelry made of lace will be wonderful gifts for friends and family!














