How to make a hobby belt for fruit trees with your own hands - video
Why are fishing belts important? If you do not take care in this way of the trees growing on the site, then through their branches the pests will quickly get to flowers and leaves first, and then to the fruits and will be very pleased with such food. And the consequences can be very deplorable - the lack of high yield, disease of trees. Therefore, it is worthwhile to learn how to make fishing belts to prevent the invasion of the enemy.
A sneak belt is a strip of anymaterial (cardboard, paper, burlap) with a width of 20 cm and a length similar to that of the tree. It is fixed on the trunk, fixing with twine, harness or soft wire. The optimal period when you should use the hunting belt for trees is summer, and it should perform its function until the deepest autumn. So you can not be afraid of the invasion of caterpillars looking for a place for themselves to winter. They also apply this protection in the spring to protect fruit trees from penetrating into their crown harmful insects.
Photo Scheme: How to Install the Fishing Belt
Dodgy belts on fruit trees needperiodically cleaned - once a week will be enough. However, such a device catches and useful insects, which means that they need to be separated from pests. To do this, the belt is shaking over the paper - "good" crawl away, and "bad" will remain, and now it must be destroyed along with the enemies. It is best to burn.
Dappled belts, made by hand for apple trees,are very effective. So for a season, this device destroys almost half of all pests. It gives results, for example, in the fight against the butterfly of the apple moth. In August, she begins to fly, and at this time to destroy such a pest is very, very difficult. But the hunting belt comes to the rescue, and a huge number of caterpillars have been caught, which will later become butterflies of the second generation.
The main ways of making hawk belts with their own hands
Dry belt is made of matting, corrugatedpaper or burlap. A strip of the above width is superimposed on the barrel, previously cleaned of the old bark. Every crack needs to be smeared, otherwise insects will find their way under the paper. Belt and below, the belt is tied with twine. Thus it is necessary to leave free edges. They will bulge, and the caterpillars will fall to the ground. Then the matter of technology - they need to be collected and destroyed.
There are also self-abrasive belts. Materials for manufacturing are similar - paper, burlap. The difference of this model is that the basis of the belt is impregnated with an insecticide (allowed to use poison). Next, the device is tied on top of the film to close the exit to the captive caterpillars, which will later perish.
Special attention should be given to glue huntersBelts that are made of wrapping paper. They are mainly used to combat non-flying pests. On the trees, such belts are worn mainly in the autumn, at the peak of invasion of insects, which descend to the trunk.
What can be used as an adhesive for trapping belts? To make it clearer how to make such an adaptation - let's talk about two technologies.
In the first variant the basis of the glue will be resin. It is necessary to take pine resin gum, rosin and petrolatum in the proportion of 10 to 1.2 to 1.5. Combine the ingredients and cook until a sticky mass is formed.
The second option is to take as a basistar and mix it with burdock oil in a proportion of 2 to 1. bring the main ingredient to a boil and mix with butter. Then the mixture is boiled for 5 hours on low heat.
Use the above methods, and you can quickly get rid of pesky pests attacking the fruit trees in your garden.
Video: the hunting belt for fruit trees with your own hands
