How to connect your phone to the Internet via a computer

There is a way out, but it will be necessary to dig deeper.

Instructions how to connect the phone to the Internet via a computer

Immediately I warn that if you do not want to bother, it's better to buy yourself a wi-fiuter or learn how to make a wi-fi access point through a PC or laptop.

Before beginning the detailed description of what and how to do, make sure that you have root-rights on the phone and for the driver on the PC, then find and download the AndroidTerminalEmulator and BusyBox.

1. 
   Connect using your USB cable to your PC;


2. 
   To enable debugging, go to the Settings menu. Options and USB debugging and the opposite of "usb debugging" is ticked;


3. 
   Disable the mode USB-drive (drive);


4. 
   Again open the "Settings" next "Wireless networks" further "Mobile networks";


5. 
   In the mobile network menu, remove the tick from the "Data transfer";


6. 
   Open the phone settings, then wirelessnetwork, then a common modem. Put a tick near the general usb-modem. In the event that you can not do this (the line with the modem is gray), restart the smartphone and perform step 6 again;


7. 
   If all the items are true, then automatic installation of the hardware drivers will begin. We wait until the process is over;


8. 
   On the PC will open a window in which we go to the "Home Network". In the event that nothing is there, then do not worry, skip the point;


9. 
   On the PC, go to the Network and Sharing Center. There you must discover a new connection;


10. 
    On the computer go to the settings of the Internet connection;


11. 
    We pass in the window to the tab "Access" and allow the mobile device to use the Internet from the computer, put a tick. In the settings, always tick. How to do it - click OK;


12. 
    Now run the AndroidTerminalEmulator application, which I asked to install at the very beginning;


13. 
    Write the following: sunetcfg;


14. 
    The addresses in line USB0 should appear. Rewrite the IP address and subnet mask. The mask looks like this (for example): 255.255.255.0, and the IP is as follows: 192.168.55.154 (you will be similar, but with different digits);


15. 
    By analogy with p.10-11 we go to the Internet connection on the PC;


16. 
    In the window click "Properties" and proceed to TCPIP protocol version 4;


17. 
    Remove the check mark from the automatic IP detectionand enter the specific address that you rewrote earlier from the emulator. The address you rewrote from the AndroidTerminalEmulator program is slightly modified, the last digit is set to 1. Example: the program issued IP 192.168.55.154, we need to enter - 192.168.55.1;


18. 
    Click the "Apply" button and close the window. We pass back to the phone;


19. 
    Launch AndroidTerminalEmulator;


20. 
    We write the commands in the application, as in the screenshot below (the last numbers written by the blue marker are the ones I took for example.) You need to enter your IP!)

That, in fact, that's all. No more dances with tambourines are needed. If everything is done correctly, then we can assume that with the question of how to connect the phone to the Internet via a computer, we sorted it out.

Do not forget that after all the settings, the deviceyou need to reboot. In the future, to connect the Internet, all 20 points do not need to do, just connect the phone to the computer, go to the menu and activate debugging and USB-modem, then, in the emulator program, we write the commands shown in the last screenshot in the guide.