New Year's toys-origami on a Christmas tree made of paper

Make a snowman: an origami scheme and a step-by-step instruction

Step 1. We take a white square sheet of paper and add it to ourselves diagonally. Expand, add on the other diagonal and again unfold.

Step 2. Now you need to fold the sheet in half. Attention! You need to do this from yourself! We unfold and fold the other sides in two - also from ourselves.

Step 3. Exactly put a square in front of you in a folded form and fold the sides inside. We have a double triangle, or, as it is called a "water bomb".

Step 4. And now we start to create the workpiecefor the snowman himself. The corners of the "bomb" on the one hand need to be lifted up, and fold the resulting triangles from top to bottom in half. Spend on them something hard, so that the fold is preserved. Unfold. Again, fold the triangles in half, but this time along the vertical - an angle to the middle. Again we conduct on the fold. Do not deploy! Upstairs there should be two pockets and two corners.

Step 5. Lower the corners down and tuck them into the pockets. The same is done on the other side of the bomb.

Step 6. But now we take the workpiece and go all outblow in the hole! We have a wonderful cube. There are three such cubes for a snowman. Naturally, they must be of different sizes.

Step 7. Draw a funny face on the smallest cube and glue the cubes together from the bottom up. A hat can also be made from a small colored cube. Do not forget to paste the fields to it.

Step 8. We will make a scarf from corrugated paper. To simulate the fringe, cut the strip around the edges. Corrugated paper can be made and twigs. At one end of the strip, make incisions for the fingers and twist them with a flagellum. After that, the remainder of the strip is also twisted into a dense bundle, grease the tip with glue and insert it into the folds of the middle dice. The snowman is ready!

Origami New Year's wreath of paper

Beginner masters of origami can make a New Year's wreath. For this, only colored paper is needed. The wreath is assembled from 8 triangular modules.

• Cut out 8 squares.



• Each square is folded in half corner to the corner.



• The resulting triangle is folded in half so that two pockets are obtained.



• Fold the figure again. To do this, we need to conditionally divide the triangle into three equal widths and bend one of them at the base, that is, the widest third. We got a module with two pockets on one side and one pouch on the other. Do the same in the other 7.



• Now - the assembly! We take the first two modules and put one of them side with two pockets into that part of the second module, on which there is only one pocket. We follow that after these actions the wreath has two sharp peaks. We also put the side of the second module with two pockets in the pocket of the next one. And so on, until all 8 modules are connected to each other.

Wreaths will turn out especially beautiful if you make it from paper of different colors or with a New Year pattern.

Origami Christmas tree of paper

Well, and how to do without Christmas tree for the New Year! The simplest version of origami was invented, probably by journalists - they make it from the magazine. You can start from any page, but from a too tight cover, it's better to get rid of it carefully.

• Bend the top corner of the page towards you at an angle of 45 degrees.



• Now add the sheet again diagonally and towards you. Strongly smoothed so that it does not straighten.



• An acute angle should be formed at the bottom, which extends beyond the boundaries of the journal. We turn it upstairs.



• In this way we add all the pages. As a result, you will get a pretty, colorful Christmas tree. The last pages are better to glue together or to connect with a stapler. If the volume seems to be inadequate, you can make a tree of 2-3 magazines.