How to start repairs in a new apartment without finishing
Start repair in a new apartment - it's alwaysa difficult and responsible step, because when you stand in an empty concrete box with bare walls, you want to do everything at once and as quickly as possible. However, you should not rush and run to buy building materials at once to all the rooms. The first thing you should do before you start any repair work is to make a competent plan and estimate the future work. This is a very important point, especially when there is not much money, because without a clear sequence and cost of work, it can happen that you simply do not have enough money for the most important elements.
How to start repairing a new building - planning
So, at the initial stage, you should drawinterior design of your future home alone or with the help of a designer. This can be done both in the old fashion on paper, and with the help of specialized computer programs, which greatly simplify this process. To begin with it is necessary to be defined with accommodation of walls (naturally, not bearing), interroom partitions, doorways and arches. You may want to disassemble one of the installed walls or, on the contrary, install an additional partition wall - all this must be planned in advance. It is also necessary to determine how all the main communications will be located (electrical wiring, sewerage, water supply and so on). Also, you should determine in advance the materials that will be used to finish the various rooms.
After planning, you can move on to the nextstage - rough finish. How to start a rough repair? Of course, with the dismantling of everything that you do not like in the apartment. Unfortunately, very often it happens that the screed and plastering in the new buildings are badly executed, so they have to be remade. Also, during the dismantling of screeds and removal of poor-quality plaster, you can do (if necessary) and work on redevelopment. After replacing the coupler and installing new interior partitions, you can proceed with the installation of electrical wiring, water supply and sanitation systems, as well as heating.
Repair in the bathroom: where to start?
In the bathroom is quite a lot of speciescommunications: this is water, and ventilation, and electricity. Therefore, it is with their wiring and should start, and after the completion of wiring all the pipes you can proceed to laying tiles and painting the ceiling. Plumbing is best installed at the very last turn, so that it is not damaged during the repair work.
How to start repairing the kitchen?
In the kitchen, as well as in the bathroom, there is enougha large number of communications, so here they are also installed in the first place. In this case, it is necessary to pay special attention to three main points - the placement of the slab, sinks and wiring. Thus, even at the stage of wiring and installation of the power network, it should be determined exactly where it will be located in your kitchen. Also, if the kitchen is supposed to install a gas column, remember that it should be located in close proximity to the chimney.
In addition, in some cases, the connection of the hood to the general ventilation system may not be possible with safety precautions, so this question should be clarified in advance.
How to start a room repair?
During the repair of the room no specialrequirements and conditions are not present, therefore it is considered rather simple object. It is recommended to start repairing the room, if necessary, by changing the windows and installing the door jamb, dismantling or installing new partitions. If no re-planning in the room is planned, then it should begin with the preparation of walls and ceiling for finishing works. Then you can do the screed filling on the floor. After the screed has dried, you can start installing wiring and roughing the walls. First of all, you need to make all the necessary finishing work on the ceiling, then go to the walls and at the very end we lay the floor covering.













