How to Install a Plate

The cooker is an integral part of the technique of any kitchen. With its help, you can cook and reheat food, and in a special compartment, even store dishes. In this article, how to install the cooker.
First of all, it should be noted that such devices are electric and gas. Of course, the way of installing such boards is significantly different.
Electric stove
To install a cooker that is powered by electricity, prepare a place for its placement, which should be chosen with convenience in mindoperation of the device. For example, to save effort and time in cooking, a sink, a cutting table and a stove are located in close proximity.
The plate must always stand firm, do not vibrate and do not stagger. As a rule, the legs of such modern devices can be adjusted in height. In order to set the slab horizontally, we recommend using a ruler-level.
The most important thing - connect the device to an electrical network. As a rule, a specialcable of appropriate power. Usually, a special connection scheme is included in the delivery of the electric plate. The device can use a single-, two- or three-phase connection, as will necessarily be written in the diagram. Also all connections must be checked for possible short circuit.
Be sure to complete all the work needed test the device, which will show the readiness of the electric plate for operation.
Gas stove
In order to install a gas-powered cooker, it is necessary first of all close the gas tap and disconnect the old plate from the gas pipeline. Next, you need to remove from the device components (brazier, grilles and so on). After that, the adjustable legs can be screwed to the plate.
Now the device can be installed in its place. We recommend to leave a small gap between the plate and the wallto make it more convenient to connect the device to the gas pipeline. Connection is best done with a flexible gas hose, which can be purchased at any construction store.
Before you connect, be sure to Install a special gasket with a metal mesh, which is usually included in the packagegas cooker. The gasket is installed in the unit connecting the device itself and the gas hose. It is necessary in order to protect the device from contamination and thus extend its service life.
The tightness of the joint can be checked with soap and water: make a strong soapy solution, then open the gas cock and apply the resulting liquid to the connection from all sides. If bubbles appear, close the tap and tighten the connection.
Now the gas stove can be pushed to the wall, but the gaps described in the instructions should be observed. After this, using the level, Adjust the legs so that the plate is positioned exactly horizontally.
In the event that the device is not equipped with adjustable legs to install the plate, will need pieces of fiberboard size 20x20 mm.
Finally it is worth noting that if you are not sure that you will be able to properly install such a device, we recommend that you seek help from specialists. The fact is that your competent security depends on the competent connection of the plate.














